Dascom 7206 Cutter Installation Guide Manual do Utilizador

– 1 –Installation and 7106 7206User Guide Auto Cutter

– 10 –CAUTIONAvoid the following conditions to ensure proper operation of the auto-cutter. The cutting blade can be very dangerous. Also, this can cau

– 11 –1. Function The auto-cutter units are designed to cut various media such as labels, tickets and tags precisely and accurately as the setting cut

– 12 –3. Checking items inside the accessory box Note Auto-cutter is not available for the printer with the peeler. You should check that all of t

– 13 –4. Auto-cutter settings “Cut On” menu will be selected automatically when the auto-cutter is installed; thus, the printer can be used without ad

– 14 – CAUTION When a paper jam has occurred, or when the auto cutter has malfunctioned, your supplier or your service representative. Never attem

– 15 –6. Cut settings The auto-cutter-related commands are described below. See the Command Reference manual for more details. The following commands

– 16 –7. Auto cut-length detection If media with a cut length shorter than the minimum cut length of 25.4mm (1.0 in) is used, the cut media may remai

– 17 –8. User maintenance If the platen of the printer becomes dirty, the cutter may perform defective cutting even if the auto cutter does not malf

– 18 –9 Troubleshooting If an error is detected, an alarm will sound and an LED on the control panel will display the nature of the error. List of err

– 19 –

– 2 –© August 2010 DASCOM Europe GmbH

DASCOM REPRESENTATIVESGERMANYDASCOM Europe GmbHHeuweg 3D-89079 UlmDeutschlandTel.: +49 (0) 731 2075 0Fax: +49 (0) 731 2075 100www.dascom.comSINGAPORED

– 3 –Installation GuideInstalling the cutter stand unit (1) Check to make sure that the printer’s power switch is turned off, then disconnect the pow

– 4 –(7) Feed the cable, in 6, so that it lies along the printer’s case. When replacing the connector cover and the motor cover, take care that the c

– 5 –(4) Remove the screw (1) fastening the motor cover, and then lift and remove the motor cover. Take care that the screw does not fall inside the p

– 6 –Installing the cutter unit (9) Plug the connector of the cutter-unit cable into the connector on the cutter stand unit. (10) Align the indentatio

– 7 –User GuideContents Notice· · · · · · · · · · · · · · · · · · · · · · · · · · · · · · · · · · · · · · · · · · · · · · · · · · ·8SAFETY SIGNS that

– 8 –Notice1.Before use, be sure to read this manual and understand. And keep it handy for reference when needed.2.Do not handle, disassemble or repai

– 9 –SAFETY SIGNS that must be strictly observed!To prevent personal injury or property damage, the following must be strictly observed. The degree